1991-96 Infiniti G20 Shift Boot

Step 1. Remove Shift Knob, by turning counter-clockwise. It may be necessary to use a wrench, as Nissan glues the knob to the shifter. Once broken free, keep twisting until the knob comes off.

Step 2. Remove Shifter surround assembly by pulling up on the rectangular panel. It will be necessary to turn the existing boot inside out. 3. Remove the boot from the shifter by taking off the rubber band, and removing the small metal ring. After these are removed, just slip the boot off the shifter. 4. Now is the hard part. There are small one way retaining washers that are holding the assembly together. As you can see, the cloth goes in between the plastic panels, and these must be separated. If the clips can't be saved, cut them off with small wire cutters. 5. Once these are removed from all four corners, carefully use a small screwdriver and break the seals that are in the middle of each side. It looks as if Nissan melted the plastic for some reinforcement. Once these are broken, the whole assembly should be separated, and you can remove the old boot. Now you can line up the holes from the new boot, and slip them onto the plastic nubs that are located in each corner of the assembly. 6. Now you can start piecing together the assembly. Slip the inner part into place. Small C-clamps from a hardware store can replace them. cents. These seemed to be good replacements for the Nissan one way washers. If you can salvage the original washers or find replacements, use them; otherwise the clamps hold well. 7. The factory assembly is sealed with melted plastic, so reseal those points with hot glue. Gluing the clamps as well adds extra security. 8. Now turn the boot inside out, pulling it through the whole assembly. Use the same rubber band and metal ring that your took off, and attach the boot to the shifter the same way you took it off. Finally, turn the boot right side out, and attach the assembly to the center console. Then re attach the shift knob, turning clockwise. That's it, you're DONE!