1985-89 Toyota Celica Shift Boot

This product is handmade in Europe and can take up to eight weeks to arrive. No returns or exchanges accepted.

What This Is

A custom-sewn leather shift boot for your 1985-89 Toyota Celica. It's the leather only: it installs on your factory frame or trim ring. It is not a complete shift boot assembly.

What's Included

• Included: 1 leather shift boot, cut and sewn to order in the material and colors you choose.
• Not included: shift knob, trim, frames or hardware. You reuse your factory parts.

Before You Order

• Fits 1985-89 Toyota Celica.
• It's made to order, so it can take up to 8 weeks to arrive and can't be returned or exchanged. Please double-check your year, fitment, and colors before ordering.
• International shipping: every piece ships from Poland, so a $15 international shipping charge applies to each item at checkout.

Installation

Difficulty: Moderate  |  Tools: screwdrivers, basic hand tools, glue or a stapler depending on your frame

You'll remove the shift knob and trim, move the new boot onto your factory frame, and reinstall.

▼ Click to Open / Close Step-by-Step Installation Guide (11 Steps)

Step 1. To change the shifter boot the console must be removed. The process is very easy. There are 8 screws that must be removed using a cross point screwdriver: 3 screws are on each side of the console (front, middle and back) Middle and back screws will require moving the seats forward and back 2 screws inside the storage compartment on the bottom.

Step 2. Remove the small plastic piece under the handbrake by putting your thumb under and pulling up as shown to the right:

Step 3. The piece just snaps out.

Step 4. Remove the shifter knob by unscrewing it from the shaft. Turn the knob counterclockwise to remove.

Step 5. Once these steps have been completed you can lift the front of the console (you may have to pull it back a little) and slide it off the shifter. The emergency brake handle may have to pulled up so it will slide through it opening.

Step 6. Filp the console over to see where the boot is attached. If you pull on boot it will snap out of the plastic clips that are holding it in place.

Step 7. Snap the new boot in place in the bottom of the console.

Step 8. Slide the console back in place guiding the boot over the shifter.

Step 9. Replace and tighten the 8 screws.

Step 10. Snap the plastic piece under the emergency brake handle back in place.

Step 11. Screw the shifter knob back on turning clockwise until tight. Do not over tighten. You should be able to get snug with handle markings in the correct orientation.

Leather care: apply a leather conditioner with UV protection every 4-6 weeks to keep it from drying out and cracking.

Options & Pricing

Choose your material, colors, and stitching color in the options above. Add-on prices are added in the cart.

Material

• Regular Leather
• Perforated Leather
• Nappa Leather +$15
• Genuine Alcantara +$25
• Faux Alcantara
• Carbon Fiber Vinyl

Two-tone: choose a second color in the options above.

Layout

• Default (Like My Factory Boot)
• 4 Panel (Stitching Forms An X) +$9
• Front to Back (Axis Of Car) +$9

Style

• Quadruple Thread +$9

Quadruple stitching color applies to the outer lines of thread.